Then we dug a hole. It was 12'x12' and 5 inches deep at the end close to the house and 7 inches deep away from the house.We graded away from the house so the rainwater would flow away from the house (so to prevent any water damage to the basement). We filled this with three loads of gravel (about 3" deep)...
...followed by one inch of sand. We then tamped it down with a tamper and tried to make it as level as possible.
In come the concrete pavers!! We got them at Home Depot for 44 cents each. They're made to look like brick (pretty effectively!), but are seriously cheaper. We laid the bricks down on the sand and gently tap them into the ground with a rubber mallet.
This part was terrible. We hadn't realized just how level the sand had to be. This part took a lot of adding sand, removing sand, and cursing. Eventually I got the hang of it though. Sand was poured over and brushed into the cracks...
And furniture and grill added! (Sand makes patio look white washed - we need to figure out how to clean it without removing sand from the cracks - any ideas?) We've also started making a garden bed in the area closest to the camera in the picture below. This will help prevent the water from collecting on the patio - and will serve for aesthetic purposes.
ReplyDeleteGate Lock with key
Gate Handles
Gate latch hardware
Hinges and latches
Gate Hardware